He has a Dish Pro LNB. The switching is done via the two LO settings. He wants V high always for propper operration of the LNB. They like the voltage to be at 18-19v
Try increasing the delay a tad. change the W15's to W20 and the first W20's to W25's. The W20's at the end I don't think are needed.
----- Original Message ----- From: "Thiemo" rollercoaster@reel-multimedia.com To: "VDR Mailing List" vdr@linuxtv.org Sent: Friday, November 09, 2007 3:07 AM Subject: Re: [vdr] VDR doesn't always switch channel correctly
Am Donnerstag 08 November 2007 schrieb Maxime Laplante:
Hi guys,
I'm running VDR 1.4.0 on my CaptiveWorks CW-3000HD FTA receiver.
My current diseqc.conf is:
# DiseqC Configuration
# Port 0 Galaxy 11 & Nimiq 1,3 S91.0W 99999 V 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 S91.0W 99999 H 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 S91.0W 99999 R 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 S91.0W 99999 L 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20
I dont see how switching the polarisation is done - as toneburst, voltage
and
diseqc commands are all the same for each polarisation. Also a repeated command should start with "E1" because "E0" would be for
the
next (cascaded) switch which is most probably not what was intended... You could also repeat the commands twice, which is the default. A correct diseqc block with 2 repeats should look like this:
S19.2E 11700 V 9750 t v W15 [E0 10 38 F0] W15 [E1 10 38 F0] W15 [E1 10
38
F0] W15 t S19.2E 99999 V 10600 t v W15 [E0 10 38 F1] W15 [E1 10 38 F1] W15 [E1 10
38
F1] W15 T S19.2E 11700 H 9750 t V W15 [E0 10 38 F2] W15 [E1 10 38 F2] W15 [E1 10
38
F2] W15 t S19.2E 99999 H 10600 t V W15 [E0 10 38 F3] W15 [E1 10 38 F3] W15 [E1 10
38
F3] W15 T
regards, T.
vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr